Heater Calculation_Linkwell Electric (Shanghai)Co.,Ltd.

Units of Length: Temperature Unit:

1. Enclosure dimensions

H (Height)		mm
W (Width)		mm
D (Depth)		mm

2. Enclosure material Heat transfer coefficient

W/m²K

3. Location of installation

Units of Length: Temperature Unit:

4. Enclosure position

Free-standing single enclosure	Free-standing first or last enclosure	Free-standing middle enclosure
Wall-mounted single enclosure	Wall-mounted first or last enclosure	Wall-mounted middle enclosure
Ground-mounted single enclosure	Ground-mounted first or last enclosure	Ground-mounted middle enclosure
Ground and Wall mounted single enclosure	Ground and Wall mounted first or last enclosure	Ground and Wall mounted middle enclosure

Units of Length: Temperature Unit:

5. Heat dissipation

The heat dissipation (=self-warming) of all installed electrical load (e.g. transformers, relays, semiconductors, bus bars, etc.) has to be taken into account if components are operated continuously.

Heat dissipation

Units of Length: Temperature Unit:

6. Climate

to maintain a minimum temperature inside of the enclosure and to avoid low temperatures

Lowest ambient temperature		°C
Desired minimum temperature inside of the enclosure		°C
(lowest temperature inside of enclosure to ensure all equipment inside of the enclosure will work properly)
Temperature difference		K

to maintain a specific humidity level in an enclosure to avoid condensation

Highest ambient temperature		°C
Highest ambient humidity (RH)		%
Desired humidity inside of enclosure (RH) (max. 65% recommended)		%
Height (above sea level) max. 2000 m or max. 6500 f		m

both

7. Result

Enclosure dimensions
Enclosure Surface Area The enclosure surface area is a result of the enclosure dimensions, as well as the enclosure position which has been considered according to VDE formula 0660 part 500.
Heat transfer coefficient
Location of installation
Enclosure position
Heat dissipation
Lowest ambient temperature
Desired minimum temperature inside of the enclosure
Temperature difference
Highest ambient temperature
Highest ambient humidity (RH)
Desired humidity inside of enclosure (RH) (max. 65% recommended)
Height (above sea level) max. 2000 m or max. 6500 f
Required heating performance

The required heating performance can also be attained by combination of multiple heaters/fan heaters.

Errors and omissions excepted. STEGO Elektrotechnik GmbH does not assume liability for the accuracy of statement. Calculated heating performance must be verified by the user under real application conditions.

8. Request calculation results


*Name：
*E-mail：
Telphone：
Address：

New distribution terminal block LK series

Heater Calculation

Required performance
of Thermal Management products

New distribution terminal block LK series

Heater Calculation

Required performance of Thermal Management products

Required performance
of Thermal Management products